Look for a small hole usually on the right side of the lever base and insert the end of a paper clip to release the detent thus allowing you to remove the lever.
How to fix a loose lever door handle.
I show how i tightened my loose door handle that is made by kwikset.
To depress the detent insert a small flat blade screwdriver through the slot to press and release the detent while twisting and removing the.
Remove the door rose by inserting a small screwdriver into the small notch in the rose and twisting the tool to pop it off.
This screw fits in a groove on the round lever rod.
Here s a quick guide on how to tighten that loose lever doorknob with hidden screws.
If it is a threaded shaft you will have to twist the shaft s handle to make it flush with the door.
Step 4 repeat on opposite side.
Use an allen wrench to remove the lever.
This type is found commonly on lever style door handles.
A loose lever requires some readjustment to properly fit into the rod assembly.
That s done by hiding the screws under a decorative cover plate that pops off but getting the doorknob off or lever in this case can be frustrating when there is no visible way to remove it.
Some lever handles have hexagonal shaped fasteners that require an allen wrench for removal.
To depress the detent use the end of a metal paper clip or the point of an awl inserting it into the hole and pressing the detent down while twisting and removing the door handle shaft off the spindle.
Keep the handle in place and replace the set screw on the bottom of the lever.
Turn the wrench to remove the fastener then pull the lever away from the door by hand.
Levers handles slide onto a rod assembly with a set screw.
When dealing with a lever door handle fixing the problem will require only the most basic of tools and about 10 minutes of time.
Tighten this with the screwdriver.
Be careful so you don t chip any door paint.
I show how i tightened my loose door handle that is made by kwikset.
Press down on the lever to reset the lock assembly.
This type is usually found on round doorknob hardware sets.
Using an awl or small screwdriver push the button in all the way and at the same time pull off the handle.
Look for these fasteners along the base of the lever then use an allen wrench that fits snugly into the head of the fastener.
Go slowly with this so you won t end up stripping the screw head.
Repeat this process for the other side of the door as well.
If exposed screws are being used you will have to find the set screw which is normally found on the inside of the door.
