Installing Attic Steps

In most cases you ll need to drill a pilot hole and install a hex head cap screw and lock nut to keep the foot in place.

Installing attic steps.

Snap chalk lines onto the ceiling to represent the rough opening of the attic staircase. Cut out the ceiling joist and any wood blocking that s in the opening. However if you are installing a new one for the first time you ll need to create a new opening for an attic access point you would need to use a hand saw for this and the measurements from step one to make the perfect cut by following the chalk lines with the handsaw just be careful of any tubes wire or duck that might be on your way. Measure and cut.

Attach rope install the pull rope on the ladder assembly by threading the rope through the hole in the door. Measure 54 inches and tap the second nail next to the same joist image 1. Install the attic ladder feet as instructed by the manufacturer. So stop worrying about how to install an attic ladder and let lowe s coordinate your attic stairs installation.

Lowe s will coordinate your attic ladder installation service to remove your old attic ladder handle your new attic stair installation and haul away the old unit. How to install pull down attic stairs cut out attic access opening. Certain steps specific to your model may not be covered here. Use a reciprocating saw to cut joists and nails holding any joists that must be removed.

Contact lowe s today to help with installing attic ladders or. Whether you already have an existing cavity in your roof or need to create a new one t. Cut out the framing around existing hatchway opening with a reciprocating saw. Improper installation may result in serious injury.

Mark rough opening of new fold down staircase on the ceiling joists in the attic. If you have a pull down attic ladder installed and only need to replace the stairs good news for you you can skip this step. The ladder length will depend on your ceiling height. Read and follow the manufacturer s instructions for your attic stair model.

Cut around ceiling trim with a utility knife. Remove joists and other obstructions. How to install an attic ladder step 1. Construct the opening.

Make sure the foot pads touch the floor and provide a. Then thread the washer included in the attic ladder kit onto the rope on the upper side of the door. Installation requires two people. Snap a chalk line between the two.